Publication Type : Conference Proceedings
Publisher : 2019 IEEE International Conference on Electrical, Computer and Communication Technologies (ICECCT), IEEE
Source : 2019 IEEE International Conference on Electrical, Computer and Communication Technologies (ICECCT), IEEE, Coimbatore, India, India (2019)
Url : https://ieeexplore.ieee.org/document/8869519
Campus : Coimbatore
School : School of Engineering
Department : Electrical and Electronics
Year : 2019
Abstract : The purpose of this work is to implement a cardiopulmonary resuscitation feedback device to recover a patient from cardiac arrest. This feedback device is implemented using ATMega 328P microcontroller. The force sensitive resistor is used to obtain the pressure applied to the patient's chest while performing chest compressions. Light Emitting Diode is used as an indicator to understand whether the chest compression performed is good or bad. 30 chest compressions make a single chest compression cycle. For each cycle, parameter like heart rate, beats per minute count andthe time rate for a particular cycle are calculated. The prototype is initially implemented in Arduino integrated development environment. The hardware is then extended to MATLAB software. For MATLAB implementation, the parameter found are computed and various graphs are plotted like the heart rate versus cardiopulmonary resuscitation count, beats per minute count versus time and heart rate versus time. From these, it is observed that BPM count decreases with increase in CPR cycle time.
Cite this Research Publication : J. Jacob, Adarsh, S. R., Ashis, C. K., and Resmi, R., “Miniaturized CPR Feedback device using Arduino and ArdLAB”, in 2019 IEEE International Conference on Electrical, Computer and Communication Technologies (ICECCT), Coimbatore, India, India, 2019.