Back close

Effect of Heat Treatment on Mechanical and Tribological Properties of Centrifugally Cast Functionally Graded Cu/Al2O3 Composite

Publication Type : Journal Article

Publisher : Journal of Tribology

Source : Journal of Tribology, ASME, Volume 140, Issue 2, p.1-7 (2018)

Url : http://dx.doi.org/10.1115/1.4037767

Campus : Coimbatore

School : School of Engineering

Department : Mechanical Engineering

Year : 2018

Abstract : A functionally graded Cu–10Sn–5Ni metal matrix composite (MMC) reinforced with 10 wt % of Al2O3 particles was fabricated using the centrifugal casting process with dimension Φout100 × Φin85 × 100 mm. The mechanical and wear resistance of the composite has been enhanced through heat treatment. Samples from of the inner zone (9–15 mm) were considered for heat treatment, as this zone has higher concentration of less dense hard reinforcement particles. The samples were solutionized (620 °C/60 min) and water quenched followed by aging at different temperatures (400, 450, and 550 °C) and time (1–3 h). Optimum parametric combination (450 °C, 3 h) with maximum hardness (269 HV) was considered for further analysis. Dry sliding wear experiments were conducted based on Taguchi's L27 array using parameters such as applied loads (10, 20, and 30 N), sliding distances (500, 1000, and 1500 m), and sliding velocities (1, 2, and 3 m/s). Results revealed that the wear rate increased with load and distance whereas it decreased initially and then increased with velocity. Optimum condition for maximum wear resistance was determined using signal-to-noise (S/N) ratio. Analysis of variance (ANOVA) predicted the major influential parameter as load, followed by velocity and distance. Scanning electron microscope (SEM) analysis of worn surfaces predicted the wear mechanism, observing more delamination due to increase in contact patch when applied load increased. Results infer 8% increase in hardness after heat treatment, making it suitable for load bearing applications.

Cite this Research Publication : Manu Sam and Dr. Radhika N, “Effect of Heat Treatment on Mechanical and Tribological Properties of Centrifugally Cast Functionally Graded Cu/Al2O3 Composite”, Journal of Tribology, vol. 140, no. 2, pp. 1-7, 2018.

Admissions Apply Now