Syllabus
Lab Content 45 hours
- Homologation trials – Acceleration test,
- Brake test,
- Single lane change test,
- Double lane change
- Steering effort – Steering torque measurement-
- Brake force measurement test- Gear shift effort
- Pitch, Yaw and roll measurement (Road test & IPG Carmaker simulation).
- Simulated Vehicle performance on road profile-creating and customizing the vehicle model to the requirement- Exercises using simulation tools (IPG Carmaker)
- Modeling an Anti-Lock Braking System-Magic Formula based Tire Modelling (Matlab)
Unit 1
Vehicle Dynamics Introduction and Steering – Load distribution – calculation of CG of a vehicle – Effect of CG on vehicle performance.- Basic equation of Acceleration, Brake performance. Acceleration – Power-Limited, traction-limited- Steering system – The Steering Linkages and settings- Steering System Forces and Moments – Steering System Models – steering ratio, under steer/over steer-Problems. Influence of Front-Wheel Drive – Four- Wheel Steer. Rollover – Quasi-Static Rollover of a Rigid Vehicle, Quasi-Static Rollover of a Suspended Vehicle, transient Rollover. Experiment with the Measurement steering wheel (MSW) and Wheel pulse transducer.
Unit 2
Brake and Tire forces: Braking Performance- Basic Equations – Braking Forces – Brake Proportioning, efficiency-Problems – Experiment with the Pedal force Transducer for evaluating the performance of vehicle body speed, wheel speed, tire longitudinal slip, and the stopping distance experienced by the vehicle. Tire Tractive and cornering Properties – Camber Thrust – Aligning Moment – Combined Braking and Corning – Conicity and Ply Steer – Tire Vibrations. Ride – Excitation sources – Vehicle Response Properties – Steady-State cornering – low speed turning and High speed cornering-problems. Simulate tire conditions to study the tire inflation pressure, stiffness, friction levels.
Unit 3
Aerodynamic forces on vehicle: Aerodynamic forces on ground vehicles – Wheel load – traction due to Aerodynamic forces – safety, performance characteristics –Problems-Three dimensional effects – Design features to reduce drag. Computational analysis and kinematic and force analysis of systems.
Objectives and Outcomes
Course Objectives
- To make the student understand the vehicle dynamics parameters
- To interpret system Modelling
- To make the student to simulate various driving conditions to analyse its parameters
- To model the block diagram to solve the system engineering problems using soft
Course Outcomes
CO |
CO Description |
CO1 |
Analyse and formulate the dynamic models for vehicle systems |
CO2 |
Evaluate the performance characteristics of vehicle dynamics under various driving conditions |
CO3 |
Demonstrate the vehicle motion and analyze the vehicle response for various driving conditions |
CO4 |
Simulate various driving conditions and experimental validation |
CO-PO Mapping
|
PO1 |
PO2 |
PO3 |
PO4 |
PO5 |
CO1 |
3 |
2 |
1 |
2 |
1 |
CO2 |
3 |
2 |
1 |
2 |
2 |
CO3 |
3 |
1 |
1 |
2 |
1 |
CO4 |
3 |
2 |
1 |
2 |
2 |
Skills acquired
Analyse the vehicle response for various driving conditions and formulate the fundamental of vehicle dynamics. Simulation of various driving conditions and experimental validation