Course

Unit 1

Preparation of Design basis report – recap of elevations, plan and section of buildings – Introduction to functions of detailing – Structural drawing for detailing – General detailing requirement – bar bending schedule – Transport, storage, fabrication, assembly and placing of steel reinforcement – Typical structural drawings – Welding

Unit 2

Detailing of (a) beams: singly, doubly, and T beams, (b) slabs: one-way, two-way, corners held down, and corners held up, (c) columns: axially loaded and bi-axially loaded, (d) beam-column joint: exterior, interior, corner, (e) footing: isolated and combined footing and (f) staircase.

Unit 3

Computer aided analysis, design, and detailing: Multi-Storey frame analyses

Pre Requisite: 

Course Objectives

To equip the students with basic understanding of detailing of RC structural elements

Understand the implication of detailing in the behaviour of building

Course Outcome

CO1: Apply the knowledge of design to detail beams and slabs

CO2: Apply the knowledge of design to detail columns, beam-column joints and footings

CO3: Analyze, design and detail structural elements in a multi-storey building using a commercially available software

CO-PO Mapping

Text Book(s)

Krishna Raju, “Structural Design and Drawing – Reinforced Concrete and Steel”, Universities Press 2005.

M.L.Gambhir, “Design of Reinforced Concrete Structures”, PHI Learning, 2009.

Pillai S.U. and Menon D, “Reinforced Concrete Design”, Tata McGraw Hill, 2009.

 Reference(s)

D.Krishnamoorthy, “Structural Design & Drawing- Vol-I&II”, CBS Publishers, 2012.

Karve, Shah, “Illustrated Design of R. C. Buildings (G+3)”, Standard Publishers Distributors, 2008.

Park and Paulay, “Reinforced Concrete Structures”, Wiley India (P) Ltd, 2010

Varghese P.C., “Limit State Design of Reinforced Concrete”, PHI Learning, 2013

P.Dayaratnam, “Design of Reinforced Concrete Structures”,Published by Medtech, New Delhi 2018

Jain A.K., “Reinforced Concrete – Limit State Design- 7th Edition”, Nem Chand & Bros., 2012

Sinha S.N., “Reinforced Concrete Design”, Tata McGraw Hill, 2014.

BIS Codes ( IS 456-2000, IS 875-1987Part (I&II), SP 16-1980, SP24-1983, SP34-1999 )

Arthur H Nilson, “Design of Concrete Structures”, Tata McGraw-Hill Publications, 2005