Programs
- M. Tech. in Automotive Engineering -
- Fellowship In Interventional Pulmonology and Pulmonary Critical care - Fellowship
Publication Type : Conference Paper
Publisher : IOP Conference Series: Materials Science and Engineering
Source : IOP Conference Series: Materials Science and Engineering, Institute of Physics Publishing, Volume 377, Number 1 (2018)
Campus : Bengaluru
School : School of Engineering
Department : Mechanical Engineering
Year : 2018
Abstract :
All the re-entry vehicles usually travel at hypersonic velocities, there are some design constraints pertaining to them such as aerodynamic drag and heat, which are mutually conflicting. A sharp edged slender body offers longer range and lesser drag but it causes higher aerodynamic heat. Generally, blunt shaped nose is used for the re-entry vehicles as it can disperse the accumulated heat to the surroundings better than sharp edged bodies. The current work focuses on reduction of aerodynamic heating by the introduction of a single jet injection on the stagnation point. Different jet angle configurations are used for the analysis by maintaining the angle of attack of the body constant. It is found that for body at 6-degree angle of attack the optimum jet angle is 9 degrees and the corresponding reduction in peak heat flux is 22.7% compared to the heat flux when the jet is at zero degrees and 33% compared to the case without jet. © Published under licence by IOP Publishing Ltd.
Cite this Research Publication : P. Visakh, Akhil, J., and Nagaraja S. R., “Effect of Counter Flowing Jet on Heat Transfer and Drag in Hypersonic Re-entry Vehicle”, in IOP Conference Series: Materials Science and Engineering, 2018, vol. 377.