Programs
- M. Tech. in Automotive Engineering -
- Fellowship In Interventional Pulmonology and Pulmonary Critical care - Fellowship
Publication Type : Journal Article
Publisher : IJERT
Source : International Journal of Engineering Research & Technology (IJERT), Volume 2, Issue 9, p.1426-1432 (2013)
Keywords : Epoxy resin, Impeller, Rapid prototyping, Reverse engineering, SLA
Campus : Coimbatore
School : School of Engineering
Department : Mechanical Engineering
Year : 2013
Abstract : A Turbocharger is a forced induction device that is used to allow more power to be produced for an engine of a given size driven by the engine’s exhaust gases is used in petrol, diesel powered cars, trucks, marine applications, aircraft etc.In exhaust gas turbo charging, part of exhaust gas energy, which would normally be wasted is used to drive a turbine. The turbine shaft is connected to a compressor, which draws in combustion air, compresses it, and then supplies it to the engine. The increased air supply enables more fuel to be burnt, thus leading to lower fuel consumption and less emission; hence the engine develops higher power. Development of impeller for turbochargers through conventional manufacturing has got many challenges due to the blade geometry complexity and high competition in industries due to cost management. The normal manufacturing route involves casting and machining this would lead the cost. Time consumption and not efficient for small manufactures. The aim of the project is to make impeller for turbochargers with great design flexibility, less time consumption by integrating the reverse engineering (RE) and rapid prototyping (RP) techniques called Stereolithography apparatus (SLA). SLA technique would give the design flexibility with reduced cost and it can be used for visualization, mechanical testing etc.
Cite this Research Publication : Mallikarjuna B. and chandrashekar, U., “Innovative Modeling and Rapid Prototyping of Turbocharger Impeller”, International Journal of Engineering Research & Technology (IJERT), vol. 2, no. 9, pp. 1426-1432, 2013.